howto/mpls
Tutorial: Run your MPLS network with BIRD
mpls label switching is faster because it's a divide and conquer search in an ordered list, compared to routing, which is a longest prefix match, which is a search in a netmask deep tree
and doing just label switching, especially with multiple labels, have consequences like
you can provide vpns, be that layer2 or layer3 on the same infra, we can source-route through arbitrary paths we want, and so on....
you can control visibility / reachability by route target export / imports, so you can hide various routes from specific endpoints, then they'll become unreachable just for them, basically rendering packet filtering unnecesary
hiding service addresses (ip / mac) from the infra resulting in less resource needs: in the simplest mpls, you dont need bgp route table only where the packet enters the network
you can hide your core from traceroute by disabling ip ttl propagation
hints:
as being layer2.5 technology, you'll need a tunnel which carry ethettype, like gre
inside the core you can do ldp, rsvp-te (strategic or auto-tunnel) or segment-routing
between two ases, you can enable ipv4/ipv6 labeled-unicast address family
to do inter-as-mpls-vpn on top of it, you can enable rr-to-rr, asbr-to-asbr or rr-to-asbr vpnv4/vpnv6/vpls/evpn peerings
more info at http://mpls.dn42/ or at http://mp.ls/
participating networks:
nop-mnt
C4TG1RL5-MNT - frr configuration Please make sure you understand how to configure and use frr before you use anything from this configuration!
planned:
Fortless